Panels, EV chargers, generators and repair across Clayton. Request a quote.
Who permits electrical work in Clayton
The Town of Clayton Inspections Department issues building permits and performs compliance inspections, and it also starts the paperwork for electrical load management switches on new construction.
Who supplies the power in Clayton
Clayton Public Power owns and operates the electric distribution system for the majority of residential customers inside town limits. Some areas, the Riverwood subdivision among them, are served by Duke Energy instead.
Clayton Public Power runs a load management program that puts a control device on equipment like the air conditioner, water heater or heat strips. If your house has one, it belongs in the conversation before a panel change or a large new circuit.
How a panel upgrade goes in Clayton
- Load calculation and a written quote. The size of the new service comes from the arithmetic on your Clayton house, not a default.
- Permit. Pulled with the Town of Clayton Inspections Department.
- Disconnect. The meter is pulled in coordination with Clayton Public Power, or Duke Energy in areas like Riverwood.
- Inspection. The finished work is inspected by Town of Clayton inspectors.
- Reconnect and paperwork. Power is restored and you keep the permit and inspection record for when you sell.
Adding an EV charger or a generator in Clayton
A Level 2 charger in Clayton is a new 240 volt circuit, so it is permitted with the Town of Clayton Inspections Department and inspected by Town of Clayton inspectors. The first question is whether the service has room for it; if it does not, the options are a lower charger setting, a load management device, or a service upgrade coordinated with Clayton Public Power, or Duke Energy in areas like Riverwood.
A generator wired into the house in Clayton needs a transfer switch or listed interlock, and that work is permitted the same way.
If the house is on Clayton Public Power's load management program, that equipment is part of the capacity question for a charger.
What Clayton houses are like
70.7% of housing units in Clayton were built in 2000 or later, 10.4% were built before 1980, and the median home was built in 2006, according to the U.S. Census Bureau's American Community Survey (2020 to 2024, all housing units).
The Clayton Historic District was listed on the National Register in 2010.
Most Clayton calls are about capacity in a newer house: whether the panel can take a Level 2 charger, a generator, or a finished basement, which a load calculation settles first.
Neighborhoods we cover in Clayton
All of Clayton, including:
- Glen Laurel
- Glen Haven
- Cobblestone
- Riverwood
In Riverwood, check the bill first: the town notes that some of those homes are on Duke rather than Clayton Public Power.
Common questions from Clayton homeowners
Who issues electrical permits in Clayton?
The Town of Clayton Inspections Department issues building permits and performs compliance inspections, and it also starts the paperwork for electrical load management switches on new construction.
Who is the electric utility in Clayton?
Clayton Public Power owns and operates the electric distribution system for the majority of residential customers inside town limits. Some areas, the Riverwood subdivision among them, are served by Duke Energy instead.
Do I need a permit to replace a panel or add a 240 volt circuit in Clayton?
Yes. North Carolina's small-project permit exemption excludes new or replaced electrical wiring and equipment, so both need a permit and an inspection.
Do you work in Glen Laurel, Glen Haven, Cobblestone and Riverwood?
Yes. Craver Electric covers all of Clayton, including those neighborhoods. Clayton is about 16 miles from downtown Raleigh.